回轉風機的齒輪箱不能進水，尤是正常運轉時，不能進入，一旦進水，很可能會造成潤滑油的失效，造成齒輪的損壞，那么設備齒輪箱進水怎么辦？下面甘肅回轉風機廠家給大家說明一下。

The gear box of the rotary fan can't be filled with water, especially during normal operation. Once it is filled with water, it is likely to cause the failure of the lubricating oil and damage the gear. So what should we do if the gear box of the equipment is filled with water? Next, Gansu rotary fan manufacturers give you an explanation.

1、冷卻水管破裂導致油箱進水，這種情況下，要及時停車，不能進行工作，如果是冷卻水管出現了破損，那么這種情況是很嚴重，停車之后，需要對油箱進行拆卸，還需要對風機的齒輪進行檢查，看是否存在損壞的情況。

1. If the cooling water pipe is damaged, the situation is very serious. After the shutdown, the oil tank needs to be disassembled, and the gear of the fan needs to be checked to see if there is any damage.

此種情況，只能拆卸維修，將水冷管修繕之后，經過測試，在重裝上去，檢查回轉風機能否正常工作。

In this case, it can only be disassembled for maintenance. After the water cooling pipe is repaired, it is tested and then re installed to check whether the rotary fan can work normally.

2、閑置風機油箱進水，如果是閑置的風機，因為人為的原因，造成的齒輪箱進水，可以打開油箱底部的泄油孔，將里面的潤滑油和水分排放干凈，然后放置幾天，讓里面的水分蒸發一下，然后再用潤滑油洗一遍，油箱注入潤滑油之后，盤動一下皮帶輪，試運行看下效果，如果存在問題，要及時停車。

2. Idle fan oil tank water, if it is idle fan, because of human reasons, caused by the gearbox water, you can open the oil drain hole at the bottom of the oil tank, the inside of the lubricating oil and water discharge clean, and then placed for a few days, let the inside of the water evaporate, and then use lubricating oil to wash again, after the oil tank is filled with lubricating oil, turn the pulley, test run to see If there is a problem, stop the car in time.

感謝您的閱讀，希望以上內容對您有所幫助，如您想了解更多精彩內容請點擊我們的官網：甘肅回轉風機廠家。

Thank you for reading, I hope the above content is helpful to you, if you want to know more wonderful content, please click our official website: Gansu rotary fan manufacturer.

相關文章： 陜西離心式風機廠家 凈化器 氣力輸送設備廠家 油煙 甘肅回轉風機廠家