回轉式鼓風機的工作準備：清理設備表面的灰塵和碎屑，并以免油混入。檢查是否忘記擰緊入口和出口的連接部件，以及管道的支撐部件是否完整。 如果管道中有焊渣和鐵屑，應將其清理。

Preparation for rotary blower: clean the dust and debris on the surface of the equipment to avoid oil mixing. Check if you forget to tighten the connecting parts of the inlet and outlet, and if the supporting parts of the pipe are complete. If there are welding slag and iron filings in the pipeline, they should be cleaned.

設備運行時，請保障油位在油位計的兩條紅線之間，設備工作時不應加油，用手沿著旋轉的方向盤移動皮帶輪或聯軸器，以檢查是否異常。設備突然故障的解決方案：當設備正常工作時，發現它突然泄漏。 完成后，再次進行處理。

When the equipment is running, please ensure that the oil level is between the two red lines of the oil level gauge. When the equipment is working, do not add oil. Move the pulley or coupling manually along the rotating steering wheel to check whether it is abnormal. Solution to sudden failure of equipment: when the equipment works normally, it is found to leak suddenly. After that, it is processed again.

高溫會切斷水和電。 真空設備害怕高溫下的斷水和斷電。 當安裝回轉式鼓風機時，建議安裝備用水箱或自來水管，替換充氣氣瓶。當需要替換設備使用的充氣氣瓶時，請拆下壓力調節閥并用一瓶新氣體進行替換，在安裝過程中請注意不要漏氣。設備可以工作一段時間，并且需要清洗和清潔以保持設備的清潔。

High temperature cuts off water and electricity. Vacuum equipment is afraid of water and power cut-off under high temperature. When installing the rotary blower, it is recommended to install a spare water tank or water pipe to replace the gas cylinder. When the gas cylinder used in the equipment needs to be replaced, please remove the pressure regulating valve and replace it with a new one. Please pay attention not to leak during installation. The equipment can work for a period of time and needs to be cleaned and cleaned to keep it clean.

回轉式鼓風機啟動時空的原因是：電動機； 電動機的電壓不變，速度不變，需求越大，工作越多。 電動機功率增加，電流增加，電流太大，維護系統停止。沒有維護系統的電動機燒毀。 風扇：風扇暴露于壓縮氣體產生的熱量中，熱量無法及時散發，風扇變熱，變軟并使風扇外殼變脆，風扇同時受到兩個外力的作用。

The reason for starting time and space of rotary blower is: motor; the voltage and speed of the motor remain unchanged, the greater the demand, the more the work. The motor power increases, the current increases, the current is too large, the maintenance system stops. The motor without maintenance system was burnt out. Fan: when the fan is exposed to the heat generated by the compressed gas, the heat can not be dissipated in time, the fan becomes hot, soft and the fan shell becomes brittle, and the fan is subject to two external forces at the same time.

相關文章： 陜西離心式風機廠家 凈化器 氣力輸送設備廠家 油煙 甘肅回轉風機廠家