文章來源： 作者：羅茨機電 發布時間：2021-11-18 瀏覽次數：861
As an efficient dust removal equipment, pneumatic conveying equipment has been applied to each production stage of concrete manufacturing industry. With the continuous development of cement production technology, bagged dust can only be used in many production stages. Emission regulations must be considered in manufacturing.
The more beneficial it is to increase the working capacity of the pneumatic conveying system, it will obviously improve the rationality. However, if the dust gas ratio is too large, it will cause blockage at the same cyclone rate, and the working pressure of the pneumatic conveyor will also increase. For pneumatic and low positive pressure pneumatic conveying systems, there will be more than air cap mechanical equipment. Allowable deep suction working pressure or exhaust pipe working pressure. Therefore, the standard value of air-to-air ratio depends on the physical properties of raw materials, such as, conveyor method and its conveyor standard.
For the positive pressure pneumatic conveying system, the specification and structure of silo pump, the nominal diameter and length of chain conveyor pipe, the number of elbows and the amount of air applied shall be considered, and the ash gas ratio is more constrained than nature. The traditional mechanical equipment conveyor processing technology, that is, the granary inlet and outlet conveyor processing technology composed of bucket elevator, belt conveyor and other conveying mechanical equipment, has many shortcomings.
Pneumatic conveying equipment belongs to dense phase high-pressure pneumatic conveying. Suitable for non fragile particles Conveyor for pneumatic conveying of granular materials. The market is used in forging, chemical plant, pharmaceutical and grain manufacturing. Pneumatic conveying equipment, gas transmission pipe, spherical tee, turbocharger, turbocharger elbow, etc. form a sealed conveying system. It can be equipped with automatic control system and electronic control system to make all systems unattended and cooperate with PLC automatic control system.